Work in Iowa Construction Jobs

Job Information

YOUNG MECHANICAL and PLUMBING INC Laborer/Plumber Helper in GREENFIELD, Iowa

Looking for laborer, plumber or plumber helper, willing to learn. Hours will vary from full time, 40 hours a week with occasional overtime as needed, in some instances, due to weather, hours may be reduced to less than 40 hours. Pay $12-$15 an hour. Assist plumbers by performing rough-ins, repairing and replacing fixtures, and locating and repairing leaking or broken pipes. Cut or drill holes in walls or floors to accommodate the passage of pipes. Measure, cut, thread and assemble new pipe, placing the assembled pipe in hangers or other supports. Mount brackets and hangers on walls and ceilings to hold pipes, and set sleeves or inserts to provide support for pipes. Requisition tools and equipment, select type and size of pipe, and collect and transport materials and equipment to work site. Fit or assist in fitting valves, couplings, or assemblies to tanks, pumps, or systems, using hand tools. Assist pipe fitters in the layout, assembly, and installation of piping for air, ammonia, gas, and water systems. Excavate and grade ditches, and lay and join pipe for water and sewer service. Cut pipe and lift up to fitters. Disassemble and remove damaged or worn pipe. Obtain and maintain required certifications. Comply with all applicable standards, policies, and procedures, including safety procedures and the maintenance of a clean work area. Repair or replace defective equipment, components, or wiring. Test electrical circuits and components for continuity, using electrical test equipment. Reassemble and test equipment following repairs. Inspect and test system to verify system compliance with plans and specifications and to detect and locate malfunctions. Discuss heating-cooling system malfunctions with users to isolate problems or to verify that malfunctions have been corrected. Record and report all faults, deficiencies, and other unusual occurrences, as well as the time and materials expended on work orders. Test pipe or tubing joints and connections for leaks, using pressure gauge or soap-and-water solution. Adjust system controls to setting recommended by manufacturer to balance system, using hand tools.

DirectEmployers